Cisco Password Reset / Recovery for Cisco Switches

Written By: cory
 on Jun 8th, 2011 at 12:56 pm

Cisco Password ResetIf you have a Cisco Catalyst switch that you cannot obtain administrative access to, recovering or resetting the administrative password can be challenging for the uninitiated. Cisco password recovery or password reset on a Cisco Catalyst switch can be confusing, and the method for recovering the password will vary depending upon the Cisco Catalyst series and model. You’ll need a few items in place before you begin to attempt a Cisco password reset:

Cisco Hyperterminal Password
Once you have the necessary hardware and software, and have installed your terminal emulation program on your PC, simply attach one end of your console cable to your PC or laptop, and attach the other end of the cable to the console port on your Cisco switch. Next, fire up your terminal emulator (be sure to select the correct COM port in the setting of your terminal emulator, typically COM1 or COM2). Cisco switches require the following terminal emulator settings in order to communicate and allow you to see the configuration dialogue in the window of your terminal emulator software:

  • Bits per second (baud): 9600
  • Data bits: 8
  • Parity: None
  • Stop bits: 1
  • Flow Control: Xon/Xoff

Next, refer to the PDF document below for step-by-step instruction on how to reset and recover the password on your Cisco Catalyst switch. This document describes the password recovery procedure for the Cisco Catalyst Layer 2 fixed configuration switches including 2900XL/3500XL, 2940, 2950/2955, 2960, and 2970 Series, as well as the Cisco Catalyst Layer 3 fixed configuration switches 3550, 3560, and 3750 Series.

Cisco Catalyst Switch Password Recovery Instructions

Leave a Reply